Trackday Riders Homepage
Forum Home Forum Home > TDR ADVERTISER > Commercial Adverts > UK Race Support
  New Posts New Posts RSS Feed - H2O Radiators
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedH2O Radiators

 Post Reply Post Reply
UK Race Support View Drop Down
Site Sponsor - Bikes Parts

Joined: 27 October 2011
Location: Chesterfield
Status: Offline
Points: 842
Direct Link To This Post Topic: H2O Radiators
    Posted: 12 April 2012 at 12:42
We have just started selling the Italian made H2O race radiators and oil coolers.

They do add-on (extra) radiators, bigger race radiators and radiator/oil cooler kits for most bikes.
The add-on radiator can reduce engine temp by about 8 degrees C whilst the bigger rads can reduce temps by 18+ degrees C.  Kits come with silicone hoses and all fittings needed to make a simple installation job possible.  They do say the bike must have a race exhaust system fitted as they may not fit with stock systems.

The Hard Facts

The more horsepower an engine creates the more heat it creates. Once an engine reaches around 85°C (185°F) you start loosing power and at about 118°C (244,4°F) you could loose 6-7 HP and ultimately risks the threat of serious damage. Cooling problems are a major cause of failures in all types of racing: the radiator is important to the performance and longevity of your racing engine.

How does it work

The radiator removes the engines unused heat. This is accomplished by the fluid which carries the heat out of the engine into the radiator. Once in the radiator the fluid moves through the tube/fin where the engine's heat is dissipated.

Why an Aluminum Racing Radiator
Although the concept of a radiator is quite simple, getting a radiator to work properly under the extreme conditions of auto racing is not as simple. Most stock motorcycle and automotive radiators are not designed to stand up to the rigors of auto racing—this includes both their strength and performance.

Most radiators for street applications are designed around the principle of getting the job done for the lowest possible cost. As a result most stock/OEM radiators are merely adequate for the task of cooling a car or motorcycle engine during normal usage—forget about under the stresses of racing. The tubes in a radiator are the primary source of cooling and the fins are secondary. Since tubing is much more expensive than fins, most stock/OEM radiators increase the amount of fins to reduce the amount of costly tubing required. A good aluminum racing radiator does just the opposite—more tube surface for primary cooling and fewer fins allowing it to cool much more effectively. The increased number of fins on a stock/OEM radiator can also adversely affect the performance of the radiator. Since additional fins allow less space for dirt and debris to pass through, it becomes harder for the air required to dissipate heat to pass through the radiator. This is very important in auto racing where more dirt, rubber and other debris is present. Additionally, the higher fin count can represent a small air restriction which causes air to flow around the sides of the radiator rather than through it. One additional thing to keep in mind is that most stock motorcycle radiators are designed to work with unrestricted airflow. When placed in a racing car behind or under bodywork it becomes much harder for them to work efficiently.
Two additional benefits of aluminum racing radiators are strength and weight. Most aluminum racing radiators have the tanks welded to the tubes rather than brazed or sealed with epoxy. This makes the radiator much stronger and more capable of standing up to the rigors of racing. Aluminum racing radiators are also much lighter than stock/OEM radiators because of the lighter materials and lower fin counts.

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.094 seconds.